Serious Stereo Amplifier specs (continued):

(5) Input: Impedance-- Greater than 300 Kilohms. Lexan ® floated RCA jack, Vampire or Ensembles best.

(6) Output: 8 ohms nominal. 4 or 16 ohm available upon request. CARDAS silver Speaker Posts are used.... mounted very close to the transformer output leads-- which are cut short for perfect power transmission, and are crimped, then Wonder-Soldered onto the Speaker Post inside terminals.

(7) Supplied Power Cord: 7 feet (2.3 meters) long. Grounded 12ga. multistrand twist, 3-conductor. Into 20-amp. IEC connector.

(8) Thermistor-controlled startup with R.F. and noise cancellation applied across the Thermistor terminals

(9) Output Transformer by Magnequest ® are re-built in-house here at Serious Stereo. This also includes powder-coatings inside & outside the Bell Covers. No detail is overlooked in building your amplifier to perfection...

(10) Carrying Handles are hot-forged Chromium-Steel with Grade 8 retainers held by Loctite ® threadlocking agents

(11) Amplifiers are 100% hand-wired in all 3 dimensions-- a must to meet our performance and repairability standards. Only the best Silver wiring available is allowed.....

(12) Simple, direct-coupled, 2-stage circuitry is used with no regulating, correcting, or otherwise musically-degrading unnecessary parts.

(13) The Chassis is laser-cut, trimmed, and welded with factory-installed "PEM" nuts to make assembly and disassembly a "snap". This is all Powder-coated inside & out to provide a tough, beautiful finish. We are proud of the inside of our equipment as well as the outside.

(14) The Chassis Bottom-Plate is also an Engineered isolation platform. Nothing is overlooked.

(15) Repairs are really easy-- except-- NO unit has ever needed it!